International Telstar Owners Association

started to work slowly on the boat...will make a topic for this rebuild
now i need some help for remaking the spreaders , i don't have them at all . i have the supports on the mast though 40mm interior so i have bought aluminium pipe OD 40mm... can any one tell me how long is one spreader for the 26" mk2 telstar ? how about a picture from the outer tip of them ?
from my calculation should be around 90cm long or 35". is this right ?

thanks

Mine are 94cm long. Hope that helps

Mike

thanks allot mike !
so 94 cm the spreader in total with the outer tip . how is there made : the cable moves freely through plastic or something like that ?

thanks

On "Trina", the shroud passes through a notch in a plastic fitting that goes in the end of the spreaders. It has a metal clip in it which stops them coming out.

I put a small SS bulldog clip on the rigging wire under the spreader to keep it at the right angle.

I have no idea where I would be able to buy a replacement!

If I find a helpful photo, I'll post it.

My spreaders are 36" tubes with a 3/4" cap.



The shrouds fit into the end caps. They're held in with stainless wire. Boots cover.