Rudder control line block locations
Posted: Thu May 30, 2019 3:31 am
The Telstar Owner’s Manual shows blocks 1, 2, and 3 used for hauling the “up” and “down” rudder control lines. Can someone describe or show a picture of where these blocks are mounted? My hull was very early, and it did not apparently include these, or the PO removed them.
From the diagram, they seem to be mounted to port of the rudder trunk, but I am not sure if they are mounted on the deck, or on the inside of the hull?
Thanks.
Andrew
Hull 304
From the diagram, they seem to be mounted to port of the rudder trunk, but I am not sure if they are mounted on the deck, or on the inside of the hull?
Thanks.
Andrew
Hull 304