Battery placement

Posts regarding the electrical systems and electronics on a Telstar.
Post Reply
occasion
Posts: 28
Joined: Sat May 02, 2009 4:32 pm
Contact:

Battery placement

Post by occasion »

Gary,
have you documented your battery installation with pics or words? I am interested in adding more battery capacity and would like to know in more detail what you have done.

Sandy
gary green
Posts: 58
Joined: Sat Jan 10, 2009 6:59 am
Contact:

Battery placement

Post by gary green »

Hi Sandy,

I've attached a couple of pictures to show the battery location and try to describe what I have done but I still have not finished all my projects. I maintain two 4D batteries. To better distribute their weight I maintain one under the starboard side under the cockpit. The other I relocated to the bow. In both areas of the bow and stern I fabricated teak and holly soles for the floor. Under the cockpit I divided the space into two sections but have yet to build the the doors to enclose it. On the starboard side and in the locker under the steps I followed the plumbing line to the Head area with conduit and wireing to relocate the second battery to the bow. I will also use this space to eventually run a shower drain line to the back of the boat but going through a shower drain sump pump. My boat was one of the earlier ones (311) and was not completely fitted out as reagrds the plumbing for the shower. At the same time I have been constructing walls to enclose the head with more room and with an eventual door. I do not think I can attach all the pictures to this post so I'll send a couple of additional posts with pictures.
Attachments
P6060002.JPG
P6060002.JPG (168.52 KiB) Viewed 1933 times
P6060003.JPG
P6060003.JPG (167.12 KiB) Viewed 1933 times
gary green
Posts: 58
Joined: Sat Jan 10, 2009 6:59 am
Contact:

Battery placement

Post by gary green »

here are some pictures of what i did under the cockpit.
Attachments
P6060008.JPG
P6060008.JPG (173.47 KiB) Viewed 1933 times
P6060006.JPG
P6060006.JPG (182.25 KiB) Viewed 1933 times
gary green
Posts: 58
Joined: Sat Jan 10, 2009 6:59 am
Contact:

Battery placement

Post by gary green »

Here is some of the work I am doing to fit out the Head and shower area.
luigisante
Posts: 319
Joined: Wed Jul 08, 2009 1:19 pm
Contact:

Battery placement

Post by luigisante »

Nice stuff. Anybody know where to get the plastic trim that is used in the head. I need for my refit.

Lou G.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests