The Telstar Owner’s Manual shows blocks 1, 2, and 3 used for hauling the “up” and “down” rudder control lines. Can someone describe or show a picture of where these blocks are mounted? My hull was very early, and it did not apparently include these, or the PO removed them.
From the diagram, they seem to be mounted to port of the rudder trunk, but I am not sure if they are mounted on the deck, or on the inside of the hull?
Thanks.
Andrew
Hull 304
Rudder control line block locations
-
- Posts: 23
- Joined: Sat Nov 26, 2016 9:07 pm
- Location: Upstate New York
- Contact:
Rudder control line block locations
Andrew
“Firefly”
Telstar 28
Hull 304
Upstate New York
“Firefly”
Telstar 28
Hull 304
Upstate New York
-
- Posts: 1136
- Joined: Mon Nov 24, 2008 6:15 pm
- Location: SW Florida
- Contact:
Re: Rudder control line block locations
Andrew -
This question belongs in the Mechanical Systems section on the site. I'm moving it there.
Ron
This question belongs in the Mechanical Systems section on the site. I'm moving it there.
Ron
Ron Marcuse
Telstar 28 #359 "Tri-Power"
Telstar 28 #359 "Tri-Power"
-
- Posts: 23
- Joined: Sat Nov 26, 2016 9:07 pm
- Location: Upstate New York
- Contact:
Re: Rudder control line block locations
Maybe I have it... I would attach the blocks to padeyes screwed to the little bulkhead that is to the port of the rudder trunk.
Andrew
“Firefly”
Telstar 28
Hull 304
Upstate New York
“Firefly”
Telstar 28
Hull 304
Upstate New York
Who is online
Users browsing this forum: No registered users and 33 guests