Rudder control line block locations

[Agprice]

The Telstar Owner’s Manual shows blocks 1, 2, and 3 used for hauling the “up” and “down” rudder control lines. Can someone describe or show a picture of where these blocks are mounted? My hull was very early, and it did not apparently include these, or the PO removed them.
From the diagram, they seem to be mounted to port of the rudder trunk, but I am not sure if they are mounted on the deck, or on the inside of the hull?

Thanks.
Andrew
Hull 304

[Ron]

Andrew -

This question belongs in the Mechanical Systems section on the site. I'm moving it there.

Ron

[Agprice]

Maybe I have it... I would attach the blocks to padeyes screwed to the little bulkhead that is to the port of the rudder trunk.